7" Submersible Motors

7" Submersible Motors

Produced for wells 180 mm. internal diameter, Impo Submersible Motor Series reduces the total purchasing cost with its high efficiency. Water lubricated radial and Kingsburry type axial bearings are maintenance-free. Hot water resistant. Pressure balancing between inner and outer side with a rubber membrane at the bottom side and with a pressure plug at the top side of the motor. All Impo product is delivered after they pass the 100% quality control and tests.

Advantages

With a diameter of 165 mm, it is produced for wells of larger than 180 mm inner diameter.

When coupled to 7 inch pumps in 8 inch inclined wells, well rehabilitation may not be required.

When used in 8 inch wells, enables larger flow rates for large pumps when compared to 8 inch motors.

Contains a special wire that is suitable for hot water applications in its standard design.

Rewindable stator reduces repair and maintenance costs.

Provides an advantage as it can be used together with 6 inch pumps in applications where mechanical strength is important.

Standart Specifications

3 insulated winding wire
Powers from 30HP to 90HP
6" NEMA shaft end and flange
Water cooled
Vertical operation
Voltage tolerance ± 10 %
Max. water temperature 50 °C
Speed 2900 / 3500 rpm
Starts per hour 10
Min. cooling flow 0,5 m/s
PVC Lead cable
Carbon - Ceramic Mechanical Seal (IP68)
S-D starting for whole range
Windings for 380 V - 400 V - 415 V in “50Hz” & 380 V - 460V in “60Hz”.
Factory filled with Franklin’s FES93 water soluble fill solution(FP below -15 °C).
Maintenance free water lubricated radial and axial bearings.
Pressure balancing between inner and outer side with a rubber diaphragm and a pressure valve.
Availability to be operated at different speeds by frequency converter (over 30 Hz).
Availability to be operated by Soft-Starter.
CW & CCW direction of rotation (Suitable for bidirectional uses).

Options

Cable Length (8 meters)
PT 100 temperature sensor
SİC Mechanical Seal (IP68)
Windings for 220V - 220/380V - 500V in 50 Hz & 220V - 220/380V in 60 Hz (Please ask & confirm with the tecnical department)
Starting DOL, S-D or dual voltage
Rubber lead cable(except 90 HP)